- Pioneer Hydraulic Co., LTD
- Dension P080 series pump Rexroth piston pump A1VO (Series 10) Dension Gold cup P6P series pump
English
العربية
Deutsch
Ελληνικά
Español
Français
Bahasa Indonesia
Italiano
Português
Русский язык
Shqip
Svenska
ไทย
Türkçe
Українська
Home> Company News> Which bearings and rod ends of SKF need to be maintained?
- AddressNo.9088 SHAHEXI ROAD, NANSHAN DISTRICT,SHENZHEN,CHINA
- Factory AddressNo.9088 SHAHEXI ROAD, NANSHAN DISTRICT,SHENZHEN,CHINA
- Worktime9:00-18:00
- Phone(Working Time)0531-85064681
- Phone(Nonworking Time)0531-85064681
- Fax0531-85064681
Which bearings and rod ends of SKF need to be maintained?
NOVEMBER 02, 2022
Bearings and rod ends requiring maintenance must be greased preparatory being taken into oper- ation. With the exception of a few applications, they must be relubricated periodically.
SKF steel/steel radial spherical plain bearings are built from bearing steel and are through-hard- ened. The high-strength sliding contact surfaces are phosphated and treated with a special run- ning-in lubricant. These bearings are used primarily in applications where there are:
- heavy static loads
- heavy alternating loads
- shock loads
They are also relatively insensitive to contamin- ants and white heats.
To facilitate relubrication, lubrication holes and grooves are provided in both the inner and outer rings of all steel/steel radial spherical plain bearings-- barring a few small sizes. SKF steel/bronze rod ends also require relubri- cation. However, requirements are less stringent than for steel/steel rod ends, as the emergency running properties of bronze are more forgiving than steel.
The multi-groove system
Standard steel/steel radial spherical plain bear- ings that must accommodate minor alignment movements under very heavy, constant direction loads are prone to lubricant starvation. To maxi- mize the effects of the lubricant under these conditions, SKF has developed the multi-groove system and manufactures all metric steel/steel radial spherical plain bearings with an outside diameter D ≥ 150 mm with the multi-groove system on the sliding surface of the outer ring as standard († fig. 8). Metric steel/steel radial spherical plain bearings with an outside diam- eter D < 150 mm may be supplied with the mul- ti-groove system on request. These bearings are identified due to the designation suffix ESL.
These lubrication grooves provide the follow- ing benefits:
- improved lubricant supply to the loaded zone
- enlarged lubricant reservoir in the bearing
- enable relubrication under load
- extended relubrication intervals
- space for wear particles and contaminants
- extended grease life
The main benefit of the multi-groove system is that it improves lubricant distribution in the
heavily loaded zone to extend service life and/or maintenance intervals.
KAWASAKI K3V63DT PISTONS
KAWASAKI K3V112DT CYLINDER BLOCK AND R.H. PLATE
KAWASAKI K3V140DT SHOE PLATE FOR HYDRAULIC OR HYDROSTATIC EXCAVATOR
KAWASAKI K3V140DT RIGHT HAND ROTATING GROUP FOR HYDRAULIC EXCAVATOR
KAWASAKI K3V63DT CYLINDER BLOCK AND L.H. PLATE FOR HYDRAULIC EXCAVATOR