- Pioneer Hydraulic Co., LTD
- Dension P080 series pump Rexroth piston pump A1VO (Series 10) Dension Gold cup P6P series pump
English
العربية
Deutsch
Ελληνικά
Español
Français
Bahasa Indonesia
Italiano
Português
Русский язык
Shqip
Svenska
ไทย
Türkçe
Українська
Home> Company News> What is the preloading method and quantity of NTN bearing？
- AddressNo.9088 SHAHEXI ROAD, NANSHAN DISTRICT,SHENZHEN,CHINA
- Factory AddressNo.9088 SHAHEXI ROAD, NANSHAN DISTRICT,SHENZHEN,CHINA
- Worktime9:00-18:00
- Phone(Working Time)0531-85064681
- Phone(Nonworking Time)0531-85064681
- Fax0531-85064681
What is the preloading method and quantity of NTN bearing？
NOVEMBER 02, 2022
The most common method of applying preload on a bearing is change the relative position of the inner and outer rings of the bearing in the axial direction while applying an axial load between bearings on opposing sides. There are two forms of preload: fixed position preload and constant pressure preload.
Preload and rigidity
The increased rigidity effect preloading has on bearings is welcomed Fig. 8.2. When the offset inner rings of a couple of paired angular contact ball bearings are compressed, each inner ring is displaced axially by the
amount δ0 and is thus given a preload, F0, in the
direction. Under this condition, when external axial load
The basic pattern, purpose and characteristics of bearing preloads are shown in Table 8.12. The fixed position preload is effective for positioning they both bearings and also for increasing the rigidity. Due to using a spring for the constant pressure preload, the preloading amount can be kept constantly, even when the distance between both bearings fluctuates under the influence of intoxicating liquor of operating heat and load.
Also, the standard preloading amount for the paired angular contact ball bearings is ushered Table 8.13. Light and normal preload is regarded prevent general vibration, and medium and heavy preload is applied especially when rigidity is required.
Fa is applied, bearing!will have an increased,
displacement by the amount δa and bearing @s
displacement will decrease. Right now the loads applied
to bearing!and @ are F! and F@, respectively.
Under the condition of no preload, bearing!will be displaced due to the amount δb when axial load Fa is applied. Since the amount of displacement, δa, is lower than δb, it indicates a higher rigidity for δa.
KAWASAKI K3V63DT PISTONS
KAWASAKI K3V112DT CYLINDER BLOCK AND R.H. PLATE
KAWASAKI K3V140DT SHOE PLATE FOR HYDRAULIC OR HYDROSTATIC EXCAVATOR
KAWASAKI K3V140DT RIGHT HAND ROTATING GROUP FOR HYDRAULIC EXCAVATOR
KAWASAKI K3V63DT CYLINDER BLOCK AND L.H. PLATE FOR HYDRAULIC EXCAVATOR